NodeRange.AutoReduce

Sub AutoReduce(PrecisionMargin As Double)

The AutoReduce method remove extra nodes, keeping the shape of the curve within a given margin of deviation.


Parameters	Description
PrecisionMargin	Specifies the maximum allowable deviation of the curve shape. This value is measured in document units of length. Specifying larger numbers leaves fewer nodes and may cause a larger distortion of the shape.

The following code example removes any extra nodes in the active shape, keeping changes in the curve’s shape within 0.01" (where inches is the document unit of measurement):

Sub Test() 
 ActiveShape.Curve.Nodes.All.AutoReduce 0.01 
End Sub